VS-270 product data sheet

VS-270 vertical inline pump, 140 m³/h. Close-coupled vertical inline pump. Suction and discharge on a common centre line so it drops into a straight pipe run without a baseplate. This data sheet states the published limits for the VS-270. Selection outside these limits requires written application-engineering approval.

Max fluid temperature: 140 °C Min fluid temperature: -10 °C Max discharge pressure: 20 bar Max viscosity: 150 cP Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Max flow rate: 140 m³/h Max head: 62 m NPSH required: 2.9 m Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Inlet connection: ANSI 150# flange DN100 4in Outlet connection: ANSI 150# flange DN100 4in Wetted material: 316 stainless steel Seal / elastomer: Single cartridge mechanical seal, carbon/SiC, EPDM elastomer Bearing arrangement: Motor bearings, no separate bearing frame Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Supply voltage: 460 V 3ph 60 Hz Ingress protection: IP55 Motor rating: 18.5 kW Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Duty: Continuous Hazardous area rating: None — general purpose Certifications: CE, UL 778 Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Overall length: 377 mm Overall width: 377 mm Overall height: 1,110 mm Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Standard factory lead time for the VS-270 is 24 calendar days from order acknowledgement when stock is not available. Lifecycle status at this revision: active.