AX-280-CI product data sheet

AX-280-CI ANSI process pump, cast iron. Horizontal end-suction process pump, 316 stainless wetted parts, single cartridge mechanical seal. Cast iron wetted parts for water and non-corrosive utility duty. This data sheet states the published limits for the AX-280-CI. Selection outside these limits requires written application-engineering approval.

Max fluid temperature: 110 °C Min fluid temperature: -20 °C Max discharge pressure: 18 bar Max viscosity: 200 cP Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Max flow rate: 140 m³/h Max head: 62 m NPSH required: 4.1 m Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Inlet connection: ANSI 150# flange DN100 4in Outlet connection: ANSI 150# flange DN100 4in Wetted material: Cast iron ASTM A48 Seal / elastomer: Single cartridge mechanical seal, carbon/SiC, NBR elastomer Bearing arrangement: Grease-lubricated deep groove ball Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Supply voltage: 460 V 3ph 60 Hz Ingress protection: IP55 Motor rating: 22 kW Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Duty: Continuous Hazardous area rating: None — general purpose Certifications: CE, UL 778 Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Overall length: 1,050 mm Overall width: 440 mm Overall height: 535 mm Values are continuous ratings at the published reference conditions. Intermittent excursions are not covered by this data sheet.

Standard factory lead time for the AX-280-CI is 32 calendar days from order acknowledgement when stock is not available. Lifecycle status at this revision: active.